The Security Alarm Installation Process
In the following photos you can see our Sterling Security alarm installer installing a Bosch wireless home security alarm system at a customer's home.
The security alarm installation process takes minimal time, usually between 90 minutes and 2 hours depending on the layout and construction materials of your home and the number of sensors required. CCTV security cameras may add a little extra time again, but not too much more. We can provide you with an accurate estimation of the time required when we visit you to provide you with your alarm quote.
The Sterling Security installer arrives and unpacks his tools.
The security alarm installer configures the alarm sensors
A few configurations are made to the security alarm hardware by the installer.
Sensors are installed throughout the house.
The installers configure the wiring of the system in the house via the ceiling trap door & then the alarm system is linked with the garage door opener.
This is a corner sensor monitoring one room.
The keypad in the garage has been connected to the wiring and the remote control set up to the keypad. Once the zone settings have been configured and the pin number for the system set the customer is taught how to use the security alarm system keypad & remote. Our alarm monitoring service has also been contacted and the alarm alert and contact procedures discusssed and set.
Another happy Sterling Security Waikato alarm system customer.
Why choose Sterling Security for your home or business?
Local alarm monitoring & local knowledge
Expert, friendly, trust worthy installers
Management that will take your phone call